Tribological Performance of Silicon Carbide-Graphite Mechanical Face Seals
2024 (English)Independent thesis Advanced level (degree of Master (Two Years)), 20 credits / 30 HE credits
Student thesis
Abstract [en]
Mechanical face seals are widely used in many industrial applications, one of them being centrifugal multi-phase flow separators. The good functioning of a mechanical seal is a classic tribological challenge: leakage rate should be minimized, hence lubricant film thickness should be as low as possible. However, if the film is too thin, extensive direct contact between the surfaces will take place, increasing friction and wear losses. This way, optimizing sealing performance is inherently a trade-off process, which aims to maximize energy efficiency and minimize maintenance costs/downtime.
In this thesis, the tribological performance of Silicon Carbide and graphite mechanical seals was evaluated. The influence of the tribosystem’s parameters (load, speed, temperature, lubricants) on the seal operation were analyzed through tests in a TE92 rotary tribometer, especially adapted to fit a full-scale separator inlet, reproducing the ring-on-ring sealing contact as realistically as possible.
Results showed that low friction/wear regimes are directly related to the formation and preservation of a SiO2/Si(OH)4 tribofilm at the interface. It was observed that a mild, tribochemichal wear due to oxidation of SiC into SiO2/Si(OH)4 was the dominant mechanism in the SiC seals. For the graphite seals, a more severe wear was observed, and abrasion was the main mechanism due to the presence of hard SiC debris in the contact.
Water is an efficient lubricant for these seals, granting stable and maintained low friction/wear regimes over all studied conditions. Milk lubrication works well for low speeds (non-pressurized seal) and up to mid internal pressure, providing even lower COF than water. However, it suffers a transition to high friction/wear regimes at more severe conditions, which should be avoided during operation.
It was also noticed that fricton/wear regime transitions are driven by contact temperature at the interface. The critical temperature for the transition to take place is seemingly independent of contact conditions (lubricant and pressure level).
Place, publisher, year, edition, pages
2024. , p. 81
Keywords [en]
Mechanical face seals, Tribology, Silicon Carbide, Graphite
National Category
Other Mechanical Engineering
Identifiers
URN: urn:nbn:se:ltu:diva-108985OAI: oai:DiVA.org:ltu-108985DiVA, id: diva2:1892813
External cooperation
Alfa Laval
Educational program
Mechanical Engineering, master's level (120 credits)
Supervisors
Examiners
2024-09-032024-08-282025-10-21Bibliographically approved