Change search
ReferencesLink to record
Permanent link

Direct link
Numerical analyses of stability of a gradually raised tailings dam
Luleå University of Technology, Department of Civil, Environmental and Natural Resources Engineering, Mining and Geotechnical Engineering.
2013 (English)Doctoral thesis, comprehensive summary (Other academic)
Abstract [en]

Numerical analyses are presented in this thesis to address potential stability problems that may occur during gradual raisings and under seismic loading conditions of Aitik tailings dam in northern Sweden. The dam is mainly raised using upstream construction method. It is planned to raise the dam gradually in several stages. Two dam parts were studied. The first dam part is a straight dam portion, and the second dam part is a corner. The main concerns associated with future raisings of the straight dam part were: (i) the stability of the dam could be affected by an increase in excess pore pressures during sequential raisings, (ii) how to gradually strengthen the dam by using rockfill berms as supports in such a way that required slope stability can be achieved with a minimum volume of rockfill berms, and (iii) if the dam is subjected to seismic loading, whether or not an increase in excess pore pressures could lead to extensive liquefaction which may cause a failure. The problems related to the dam corner were that tension zones and/or low compression zones could develop because of the horizontal pressure of the stored tailings on the inside of the curvature of the dam corner.Numerical analyses were conducted on both the dam parts using finite element method. Two dimensional (2D) plane strain finite element model was utilized to analyse the straight dam. The dam corner was analysed with both the three dimensional (3D) finite element model, and the 2D axisymmetric finite element model. Coupled deformation and consolidation analyses, and slope stability analyses were performed on both the dam parts to simulate gradual raisings, and to compute safety factors. In addition to this, dynamic analyses were carried out on the straight dam part to evaluate the potential for liquefaction, and seismic stability of the dam. The seismic behaviour of the dam was analysed for two cases: (i) a normal case (earthquake of 3.6 Swedish local magnitude), and (ii) an extreme case (earthquake of 5.8 moment magnitude).The results of the straight dam part, with only previously existing rockfill berms, indicate that stability of the dam was reduced due to an increase in excess pore pressures during raisings. Rockfill berms were utilized as supports to raise the dam with enough safety. An optimization technique was utilized to minimize the volume of rockfill berms. This technique could result in significant saving of cost of rockfill berms.The results of the dam corner show that tension zones and/or low compression zones were located on the surface of the dam corner, mainly above the phreatic level. It is interpreted that there is no risk of internal erosion through the embankments because no seepage path occurs above the phreatic level, and a filter zone exists along the slope of the dam. It is suggested to gradually strengthen the dam corner with rockfill berms. The results of the 2D axisymmetric analyses of the dam corner were in a fairly good agreement with those of the 3D analyses. This implies that the 2D axisymmetric analyses are valid for this dam corner. This is an important finding as 2D axisymmetric analyses require much less computational time compared to 3D analyses.The results of the dynamic analyses performed on the straight dam (including additional rockfill berms) suggest that, for the extreme case, liquefaction could occur in a limited zone that is located below the surface near the embankments. For both the normal and the extreme case, (i) seismically induced displacements seem to be tolerable, and (ii) the post seismic stability of the dam is considered to be sufficient.The findings of this study have been practically applied to the Aitik tailings dam. In general, the modelling procedure and the optimization technique to minimize volume of rockfill berms, presented in this study, could be applied to other tailings dams.

Place, publisher, year, edition, pages
Luleå: Luleå tekniska universitet, 2013. , 154 p.
Doctoral thesis / Luleå University of Technology 1 jan 1997 → …, ISSN 1402-1544
Keyword [en]
tailings dams, consolidation, rockfill berms, slope stability, corner, internal erosion, finite element analysis, Civil engineering and architecture - Geoengineering and mining engineering
Keyword [sv]
Samhällsbyggnadsteknik och arkitektur - Geoteknik och gruvteknik
Research subject
Soil Mechanics
URN: urn:nbn:se:ltu:diva-26598Local ID: f1e51251-5b71-4975-8a5a-7149e68347e1ISBN: 978-91-7439-648-5ISBN: 978-91-7439-649-2 (PDF)OAI: diva2:999764
Godkänd; 2013; 20130513 (muhauc); Tillkännagivande disputation 2013-05-20 Nedanstående person kommer att disputera för avläggande av teknologie doktorsexamen. Namn: Muhammad Auchar Zardari Ämne: Geoteknik/Soil Mechanics and Foundation Engineering Avhandling: Numerical Analyses of Stability of a Gradually Raised Tailings Dam Opponent: Professor Daichao Sheng, School of Engineering, The University of Newcastle, New South Wales, Australia Ordförande: Professor Sven Knutsson, Institutionen för samhällsbyggnad och naturresurser, Luleå tekniska universitet Tid: Torsdag den 13 juni 2013, kl 10.00 Plats: F1031, Luleå tekniska universitetAvailable from: 2016-09-30 Created: 2016-09-30Bibliographically approved

Open Access in DiVA

fulltext(17717 kB)0 downloads
File information
File name FULLTEXT01.pdfFile size 17717 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Zardari, Muhammad Auchar
By organisation
Mining and Geotechnical Engineering

Search outside of DiVA

GoogleGoogle Scholar
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 5 hits
ReferencesLink to record
Permanent link

Direct link