Change search
ReferencesLink to record
Permanent link

Direct link
Tribology of elastomeric seal materials
2009 (English)Doctoral thesis, comprehensive summary (Other academic)
Abstract [en]

Elastomers are the most commonly used materials for various sealing applications owing to their low modulus of elasticity, large elongation-at-break, and high Poisson's ratio. Most seals operate in the presence of lubricants; therefore the sealing elastomeroil interaction plays an important role in determining the tribological performance of elastomers. Furthermore, at times, such as starting up periods, the seals may also operate under dry condition and the seal material can be affected by high friction coefficient and wear.In this work, the tribological behaviour of different sealing elastomers has been studied. The influence of ageing of a sealing elastomer in different lubricants on its tribological behaviour has been investigated. Further studies pertaining to the influence of lubrication on the abrasive wear of a sealing elastomer have also been carried out.The results show that the friction coefficient of an elastomer in lubricated sliding against a hard counterface, at low contact pressure, depends on the surface topography of the elastomer but at high contact pressure, it is mainly due to the viscoelastic deformations of the rubber by the counterface surface asperities. (Even if the hard surface appears smooth to the naked eye, it may exhibit short-wavelength roughness, which may make the dominant contribution to rubber friction). Ageing of the nitrile rubber in ester base fluids leads to reduction of friction coefficient.In unidirectional dry sliding of an elastomer against a counterface, the friction coefficient decreases during the running-in period. The longest running-in periods have been observed when the elastomers slide against relatively smooth surfaces. Depending on the elastomer-lubricant compatibility, abrasive coarseness, geometry of sliding contact area and contact pressure, the two body abrasive wear of elastomers may increase or decrease in presence of lubricants.Aging of nitrile rubber in lubricating fluids increases the abrasive wear both in dry and lubricated conditions. The abrasive wear of nitrile rubber in ester base fluids and rapeseed oil are higher than that in the mineral oils.

Place, publisher, year, edition, pages
Luleå: Luleå tekniska universitet, 2009. , 121 p.
Doctoral thesis / Luleå University of Technology 1 jan 1997 → …, ISSN 1402-1544
Research subject
Machine Elements
URN: urn:nbn:se:ltu:diva-18512Local ID: 8fa29f20-17c1-11de-b1a6-000ea68e967bISBN: 978-91-86233-26-6 (print)OAI: diva2:991521
Godkänd; 2009; 20090323 (mohmof); DISPUTATION Ämnesområde: Maskinelement Opponent: Professor Jozé Vizintin, University of Ljubljana, Slovenien Ordförande: Professor Braham Prakash, Luleå tekniska universitet Tid: Fredag den 17 april 2009, kl 10.00 Plats: D 770, Luleå tekniska universitetAvailable from: 2016-09-29 Created: 2016-09-29Bibliographically approved

Open Access in DiVA

fulltext(8633 kB)9 downloads
File information
File name FULLTEXT01.pdfFile size 8633 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Mofidi, Mohammad

Search outside of DiVA

GoogleGoogle Scholar
Total: 9 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 2 hits
ReferencesLink to record
Permanent link

Direct link