Change search
ReferencesLink to record
Permanent link

Direct link
Optimization of structured adsorbents for gas separation processes
Luleå University of Technology, Department of Civil, Environmental and Natural Resources Engineering, Sustainable Process Engineering.
2011 (English)Doctoral thesis, comprehensive summary (Other academic)
Abstract [en]

Conventional gas separation processes using packed beds of beads or granules suffer from high pressure drop and mass transfer resistance when higher throughputs are required, leading to lower productivity and recovery and higher power consumption. This restricts their application to low throughputs and makes them less attractive compared to other processes for large volume production and high productivity. Such problems could be reduced if structured adsorbents are developed and replace the traditional beds of beads or granules. Although much research has been devoted to the development of structured adsorbents over the last decade, there is still a need to increase the understanding of structured adsorbents. Therefore, this work aimed to increase the fundamental understanding of structured adsorbents using two different approaches; a general approach by which numerical models were developed to predict the performance of structured adsorbents with different geometries in pressure/vacuum swing adsorption (PSA/VSA) processes. The effects of parameters such as porosity, density and surface area, on performance of structured adsorbents with different geometries were evaluated. Comparisons based on mass and heat transfer, adsorbent loading and pressure drop characteristics of PSA systems for CO2/N2 separation were carried out. The obtained results demonstrate the potential advantage of structured adsorbents in rapid cycle adsorption processes. The even flow distribution, very low mass and heat transfer resistances and low pressure drop in combination with considerable adsorption capacity in the best structured adsorbents indicate that these novel configurations are promising adsorbents for PSA/VSA applications. The second approach was to evaluate the performance of zeolite coated monoliths prepared and tested experimentally by numerical modelling. The effects of wall porosity, channel width distribution and zeolite film thickness on the dynamic behavior of the adsorbents were examined. The model indicated that the film thickness could be increased up to about 10 µm to increase adsorption capacity without increasing the dispersion in the system further. In addition, it was shown that employment of monoliths with lower wall porosity would lead to better performance of the structured adsorbents.

Place, publisher, year, edition, pages
Luleå: Luleå tekniska universitet, 2011.
Doctoral thesis / Luleå University of Technology 1 jan 1997 → …, ISSN 1402-1544
Research subject
Chemical Technology
URN: urn:nbn:se:ltu:diva-17740Local ID: 4f2dcb55-d3a1-4cac-acc1-62dea322f70bISBN: 978-91-7439-233-3 (print)OAI: diva2:990745
Godkänd; 2011; 20110309 (fatrez); DISPUTATION Ämnesområde: Kemisk teknologi/Chemical Technology Opponent: Professor Alirio Rodrigues, Dept. of Chemical Engineering, University of Porto, Portugal Ordförande: Professor Jonas Hedlund, Institutionen för samhällsbyggnad och naturresurser, Luleå tekniska universitet Tid: Fredag den 13 maj 2011, kl 10.00 Plats: C305, Luleå tekniska universitetAvailable from: 2016-09-29 Created: 2016-09-29Bibliographically approved

Open Access in DiVA

fulltext(1583 kB)32 downloads
File information
File name FULLTEXT01.pdfFile size 1583 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Rezaei, Fateme
By organisation
Sustainable Process Engineering

Search outside of DiVA

GoogleGoogle Scholar
Total: 32 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 11 hits
ReferencesLink to record
Permanent link

Direct link