Change search
ReferencesLink to record
Permanent link

Direct link
Study of multiple draw-zone interaction in block caving mines by means of a large 3D physical model
University of Queensland, Brisbane.
University of Chile, Santiago.
Anglo Coal Australia.
2008 (English)In: International Journal of Rock Mechanics And Mining Sciences, ISSN 1365-1609, E-ISSN 1873-4545, Vol. 45, no 7, 1044-1051 p.Article in journal (Refereed) Published
Abstract [en]

Current production level design guidelines in block caving mines are based on the concept of interaction of movement zones and the spacing of draw-points at which mass flow is achieved. The limit of the isolated movement zone (IMZ) interaction has been determined by observations of the flow of sand and finely fragmented caved rock. This paper presents a study of the mechanisms and limit of IMZ interaction in coarse fragmented caved rock using a large 3D physical model. Results showed that when drawing from multiple drawpoints, the unmoved zone between IMZs is characterised by an increase in vertical load and a decrease in horizontal load. However, it was observed that the unmoved zones between the movement zones of adjacent draw-points did not enter the flow zone, despite drawpoints being spaced at less than 1.2 times the width of the IMZ. This result is in marked contrast to previous findings obtained in sand models, where movement zones have been observed to interact at draw-point spacings up to 1.5 times the width of the IMZ. The major reasons for the differences between the two different model results was found to be that significant stress arching and less induced vertical stress during flow was observed in the gravel model, in contrast to limited stress arching and more induced vertical stress in the sand models. It is hypothesised that significant stress arching would occur in block caving mines, and therefore that the results obtained in the gravel model maybe more representative of full-scale conditions. Movement zones in block caving mines may therefore not interact at draw-point spacings greater than the width of the isolated movement zone.

Place, publisher, year, edition, pages
2008. Vol. 45, no 7, 1044-1051 p.
Keyword [en]
Block caving, Gravity flow, Draw control, Civil engineering and architecture - Geoengineering and mining engineering
Keyword [sv]
Samhällsbyggnadsteknik och arkitektur - Geoteknik och gruvteknik
Research subject
Future mining (AERI); Mining and Rock Engineering
URN: urn:nbn:se:ltu:diva-14549DOI: 10.1016/j.ijrmms.2007.11.002Local ID: deb8ca46-99b5-4441-b961-4ccc39af350cOAI: diva2:987522
Upprättat; 2008; 20160310 (adrhal)Available from: 2016-09-29 Created: 2016-09-29

Open Access in DiVA

fulltext(1125 kB)1 downloads
File information
File name FULLTEXT01.pdfFile size 1125 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Other links

Publisher's full text

Search in DiVA

By author/editor
Halim, Adrianus
In the same journal
International Journal of Rock Mechanics And Mining Sciences

Search outside of DiVA

GoogleGoogle Scholar
Total: 1 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Altmetric score

Total: 1 hits
ReferencesLink to record
Permanent link

Direct link