High temperature corrosion in biomass-fired energy applications: Alloying effects and test environment comparisons
2016 (English)Doctoral thesis, comprehensive summary (Other academic)
To reduce the greenhouse effect, the use of renewable fuel has to be increased. As renewable fuel has different characteristics compared to fossil fuel regarding content of trace metals, alkali, chlorine and sulphur, the corrosion characteristics in high temperature energy processes have to be evaluated. This thesis concerns high temperature corrosion in the superheater region of a boiler and the syngas cooler area of a gasifier.
For the superheater region, laboratory exposures were performed. The methods included a salt dip exposure, where samples were dipped in an equimolar solution of ZnCl2 and KCl, and two salt bed exposures with different chlorine concentrations, 10 and 20 wt%. Ranking of the materials showed that a Ni content above 10 wt% and Cr above 20 wt% reduced corrosion rates in the salt dip and in the 10% Cl salt bed exposure. For exposure in the 20% Cl bed, even higher alloying was needed. An alumina forming austenitic steel showed future potential in sulphidising-chlorinating environments.
For the gasifier region, the effect of HCl in a simulated gasifier atmosphere was studied and also samples exposed in the syngas section of a biomass gasifier were investigated. Metal loss was low for all exposures and it was observed that chlorine had minor influence. For the plant exposed samples, a difference compared to that reported for coal gasifiers was the absence of FeS for the lowest alloyed steel. Instead, a deposit with pronounced content of Zn, Ca, S and O was present on the surface. Zinc was suggested to mitigate corrosion.
Thermodynamic modelling was used to explain phases present and to predict the nitridation behaviour of an alumina forming austenitic steel. Equilibrium and kinetic modelling of the nitridation showed good coherence with the observed microstructures. However, the kinetic modelling resulted in larger nitridation depths than observed experimentally which was attributed to the presence of a thin oxide layer on the surface of the samples.
Place, publisher, year, edition, pages
Stockholm: KTH Royal Institute of Technology, 2016. , xvi, 71 p.
TRITA-CHE-Report, ISSN 1654-1081 ; 2016:17
High temperature corrosion, biomass, waste, superheater corrosion, austenitic steel, biomass gasification, alumina-forming austenitic stainless steel, thermodynamic modelling, kinetic modelling
Metallurgy and Metallic Materials Inorganic Chemistry
Research subject Chemistry
IdentifiersURN: urn:nbn:se:kth:diva-186318ISBN: 978-91-7595-935-1OAI: oai:DiVA.org:kth-186318DiVA: diva2:926844
2016-06-03, F3, Lindstedtsv.26, KTH-Campus, Stockholm, 10:00 (English)
Tatlock, Gordon, Professor
Pettersson, Rachel, ProfessorOdnevall Wallinder, Inger, ProfessorNorling, Rikard
FunderSwedish Energy Agency
QC 201605102016-05-102016-05-102016-09-26Bibliographically approved
List of papers