MEMS-based electrochemical gas sensors and wafer-level methods
2015 (English)Doctoral thesis, comprehensive summary (Other academic)
This thesis describes novel microel ectromechanical system (MEMS) based electrochemical gas sensors and methods of fabrication.
This thesis presents the research in two parts. In the first part, a method to handle a thin silicon wafer using an electrochemically active adhesive is described. Handling of a thin silicon wafer is an important issue in 3D-IC manufacturing where through silicon vias (TSVs) is an enabling technology. Thin silicon wafers are flexible and fragile, therefore difficult to handle. In addressing the need for a reliable solution, a method based on an electrochemically active adhesive was developed. In this method, an electrochemically active adhesive was diluted and spin coated on a 100 mm diameter silicon wafer (carrier wafer) on which another silicon wafer (device wafer) was bonded. Device wafer was subjected to post processing fabrication technique such as wafer thinning. Successful debonding of the device wafer was achieved by applying a voltage between the two wafers. In another part of the research, a fabrication process for developing a functional nanoporous material using atomic layer deposition is presented. In order to realize a nanoporous electrode, a nanoporous anodized aluminum oxide (AAO) substrate was used, which was functionalized with very thin layers (~ 10 nm) of platinum (Pt) and aluminum oxide (Al2O3) using atomic layer deposition. Nanoporous material when used as an electrode delivers high sensitivity due to the inherent high surface area and is potentially applicable in fuel cells and in electrochemical sensing.
The second part of the thesis addresses the need for a high performance gas sensor that is applicable for asthma monitoring. Asthma is a disease related to the inflammation in the airways of the lungs and is characterized by the presence of nitric oxide gas in the exhaled breath. The gas concentration of above approximately 50 parts-per-billion indicates a likely presence of asthma. A MEMS based electrochemical gas sensor was successfully designed and developed to meet the stringent requirements needed for asthma detection. Furthermore, to enable a hand held asthma measuring instrument, a miniaturized sensor with integrated electrodes and liquid electrolyte was developed. The electrodes were assembled at a wafer-level to demonstrate the feasibility towards a high volume fabrication of the gas sensors. In addition, the designed amperometric gas sensor was successfully tested for hydrogen sulphide concentration, which is a bio marker for bad breath.
Place, publisher, year, edition, pages
Stockholm: KTH Royal Institute of Technology, 2015. , xiv, 77 p.
TRITA-EE, ISSN 1653-5146 ; 2015:030
MEMS, gas sensors, electrochemical, nitric oxide, hydrogen sulphide, nafion, nano
Engineering and Technology
IdentifiersURN: urn:nbn:se:kth:diva-172955ISBN: 978-91-7595-661-9OAI: oai:DiVA.org:kth-172955DiVA: diva2:851003
2015-10-02, Q2, Osquldas väg 10,, Stockholm, 10:00 (English)
Spetz, Anita Lloyd, Professor
Stemme, Göran, ProfessorNiclas, Roxhed, Docent
FunderEU, European Research Council, 267528VINNOVASwedish Research Council
QC 201509072015-09-072015-09-032015-09-07Bibliographically approved
List of papers