Change search
ReferencesLink to record
Permanent link

Direct link
Finite element analysis of winding sequence for cable drums
Linköping University, Department of Management and Engineering, Solid Mechanics. Linköping University, Faculty of Science & Engineering.
Linköping University, Department of Management and Engineering, Solid Mechanics. Linköping University, Faculty of Science & Engineering.
2015 (English)Independent thesis Advanced level (degree of Master (Two Years)), 20 credits / 30 HE creditsStudent thesis
Abstract [en]

This project concerns large cable drums made of steel. Cable drums are cylindrical structures used to transport different kinds of cables or wires. The ones in focus in this work are used to transport very stiff and heavy cables to offshore sites in the oil industry. To reduce weight in structures is always of great interest, and for cable drums, that are designed according to standards, there is much that can be improved.

The aim of this project is to predict the loads acting on a drum during the winding of cables. This was accomplished by performing explicit finite element simulations of the winding sequence. Modeling and meshing were done using LS-PrePost and ANSA, and the winding was simulated using LS-DYNA. LS-PrePost was also used to analyze the results, together with mETApost.

A number of simplifications and delimitations have been made in order to make the simulation possible within the time frame of the project. Simplified models of both the cable and the drum have been used. Winding velocities in real life are really slow, so in order to reduce simulation times, the winding velocity had to be increased while still avoiding dynamic effects. From this, contact forces between the drum and the cable could be obtained. The contact forces were investigated with respect to different friction values between the cable and the drum, for the cable itself and also for different cable stiffnesses.

The results obtained from the simulations provide contact force distributions for different parts of the drum. Much fewer rows and layers of cable were winched than in real life, and it is therefore hard to see any clear trends in the obtained forces. However, one important result of the contact forces, is that a previously used assumption, namely that the pretension of the cable only applies loads to a small fraction of the drum, was a bit too conservative. According to the simulations it actually gets distributed over the whole drum.

It is hard to draw any conclusions from the obtained contact forces, due to the small size of the simulations. The conclusion one can draw from this report, is that it is fully possible to use finite element tools to simulate the winding sequence of cable drums and this report presents a methodology on how to achieve this. LS-DYNA handles the contact definitions in an adequate way and is, according to the authors, a strong candidate for future work in this area. 

Place, publisher, year, edition, pages
2015. , 50 p.
National Category
Applied Mechanics
URN: urn:nbn:se:liu:diva-120075ISRN: LIU-IEI-TEK-A--15/02305—SEOAI: diva2:839984
External cooperation
Alten Sverige AB
Subject / course
Solid Mechanics
Available from: 2015-08-19 Created: 2015-07-06 Last updated: 2015-08-19Bibliographically approved

Open Access in DiVA

fulltext(2509 kB)100 downloads
File information
File name FULLTEXT01.pdfFile size 2509 kBChecksum SHA-512
Type fulltextMimetype application/pdf

By organisation
Solid MechanicsFaculty of Science & Engineering
Applied Mechanics

Search outside of DiVA

GoogleGoogle Scholar
Total: 100 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 132 hits
ReferencesLink to record
Permanent link

Direct link