Change search
ReferencesLink to record
Permanent link

Direct link
Active Control of Machine Tool Chatter
Responsible organisation
1999 (English)Conference paper (Refereed) Published
Abstract [en]

In the turning operation chatter or vibration is a frequent problem, which affects the result of the machining, and, in particular, the surface finish. Tool life is also influenced by vibration. Severe acoustic noise in the working environment frequently occurs as a result of dynamic motion between the cutting tool and the workpiece. By proper machine design, e.g. improved stiffness of the machine structure, the problem of relative dynamic motion between cutting tool and workpiece may be partially solved. However, by active control of machine-tool vibration, a further reduction of the dynamic motion between cutting tool and workpiece can be achieved. It was found that adaptive feedback control based on the filtered-x LMS-algorithm, enables a reduction of the vibration by up to 40 dB at 1.5 kHz and by approximately 40 dB at 3 kHz. The active control performed a broadband attenuation of the sound pressure level by up to 35 dB. A significant improvement of the workpiece surface was also observed.

Place, publisher, year, edition, pages
Orlando Florida, 1999.
National Category
Signal Processing
URN: urn:nbn:se:bth-10159ISI: 000079283700275Local ID: diva2:838218
International Modal Analysis Conference-XVII(IMAC-XVII)
Available from: 2012-09-18 Created: 2002-11-12 Last updated: 2015-06-30Bibliographically approved

Open Access in DiVA

fulltext(557 kB)8 downloads
File information
File name FULLTEXT01.pdfFile size 557 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Håkansson, LarsClaesson, Ingvar
Signal Processing

Search outside of DiVA

GoogleGoogle Scholar
Total: 8 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 35 hits
ReferencesLink to record
Permanent link

Direct link