Change search
ReferencesLink to record
Permanent link

Direct link
Adaptive Feedback Control of Machine-Tool Vibration based on The Filtered-x LMS Algorithm
Responsible organisation
1998 (English)In: Journal of Low Frequency Noise Vibration and Active Control, ISSN 0263-0923, Vol. 17, no 4, 199-213 p.Article in journal (Refereed) Published
Abstract [en]

Adaptive feedback control of tool vibrations during metal cutting in a lathe has been investigated. The vibrations were controlled in the primary cutting direction and the control is based on the filtered-x LMS-algorithm. It was found that the adaptive feedback control can achieve a reduction of the tool vibrations with up to 35 dB at 1.7 kHz and simultaneously with approximately 30 dB at 3.1 kHz. A significant improvement of the workpiece surface was experienced together with a substantial reduction of the acoustic noise level with adaptive feedback control. Tool life is also expected to be extended and the material removal rate can probably be increased.

Place, publisher, year, edition, pages
1998. Vol. 17, no 4, 199-213 p.
National Category
Signal Processing
URN: urn:nbn:se:bth-10089Local ID: diva2:838118
Available from: 2012-09-18 Created: 2002-11-07 Last updated: 2015-06-30Bibliographically approved

Open Access in DiVA

fulltext(607 kB)32 downloads
File information
File name FULLTEXT01.pdfFile size 607 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Håkansson, LarsClaesson, Ingvar
In the same journal
Journal of Low Frequency Noise Vibration and Active Control
Signal Processing

Search outside of DiVA

GoogleGoogle Scholar
Total: 32 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 3041 hits
ReferencesLink to record
Permanent link

Direct link