Change search
ReferencesLink to record
Permanent link

Direct link
Identification of the Statistical Properties of the Cutting Tool Vibration in a Continuous Turning Operation: Correlation to Structural Properties
Responsible organisation
1997 (English)In: Mechanical Systems & Signal Processing, ISSN 0888-3270 , Vol. 11, no 3, 459-499 p.Article in journal (Refereed) Published
Abstract [en]

The cutting force dynamics in alloyed steel, stainless steel and cast iron have been investigated, although a direct measurement of the cutting forces could not be carried out. Usually, the response of the tool holder shank is measured by strain gauges and will be dependent on the stochastic character of the applied load and the structural dynamic properties of the tool holder. The characterisation of the dynamic response of the tool holder shank relies here on a stochastic approach while the structural dynamic properties were evaluated by a normal mode analysis. The results from both the analysis and the experiments correlate well.

Place, publisher, year, edition, pages
Academic Press , 1997. Vol. 11, no 3, 459-499 p.
National Category
Signal Processing Applied Mechanics
URN: urn:nbn:se:bth-9826Local ID: diva2:837780
Available from: 2012-09-18 Created: 2002-11-07 Last updated: 2015-06-30Bibliographically approved

Open Access in DiVA

fulltext(1491 kB)50 downloads
File information
File name FULLTEXT01.pdfFile size 1491 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Håkansson, LarsClaesson, Ingvar
Signal ProcessingApplied Mechanics

Search outside of DiVA

GoogleGoogle Scholar
Total: 50 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 48 hits
ReferencesLink to record
Permanent link

Direct link