Change search
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf
Experimental evaluation setup to Measure Inductor Current in a Buck Converter
Blekinge Institute of Technology, School of Engineering.
Blekinge Institute of Technology, School of Engineering.
2011 (English)Independent thesis Advanced level (degree of Master (Two Years))Student thesis
Abstract [en]

In this thesis work we constructed a measurement circuit for measurement of the inductor current in the buck converter BMR450. We theoretically show that the voltage across the capacitor is directly proportional to the inductor current in the BMR450. We designed a test bed to enable the measurement of the inductor current. On the base of the measurement signal we derived the average inductor current for different resistive loads. We draw schematic PCB layout for the measurement circuit. During the project we observed that the measurement electronics has to be chosen for relatively high bandwidth, about 2MHz. We also observed that the measurement signal has a large noise magnitude, induced by the transistor switchings. The noise magnitude directly after the switching is so high that the part of the measurement signal was not used in the further calculations.

Place, publisher, year, edition, pages
2011. , 54 p.
Keyword [en]
DC-DC Converters, BMR450
National Category
Signal Processing
Identifiers
URN: urn:nbn:se:bth-4024Local ID: oai:bth.se:arkivex88153307CFDB9B2EC12578AF005FD2B6OAI: oai:DiVA.org:bth-4024DiVA: diva2:831343
Uppsok
Technology
Supervisors
Note
Subash Nemani Polhemsgatan 28 B karlskrona, sweden 37140 Mobile No:0764602917Available from: 2015-04-22 Created: 2011-06-14 Last updated: 2015-06-30Bibliographically approved

Open Access in DiVA

fulltext(1509 kB)