Change search
ReferencesLink to record
Permanent link

Direct link
Study Comparison of WCDMA and OFDM
Blekinge Institute of Technology, School of Engineering, Department of Telecommunication Systems.
Blekinge Institute of Technology, School of Engineering, Department of Telecommunication Systems.
2007 (English)Independent thesis Advanced level (degree of Master (One Year))Student thesis
Abstract [en]

Wideband Code Division Multiple Access (WCDMA) is one of the main technologies for the implementation of third-generation (3G) cellular systems. It is based on radio access technique proposed by ETSI Alpha group and the specifications was finalised 1999. WCDMA is also known as UMTS and has been adopted as a standard by the ITU under the name “IMT-2000 direct spread”. The implementation of WCDMA will be a technical challenge because of its complexity and versatility. The complexity of WCDMA systems can be viewed from different angles: the complexity of each single algorithm, the complexity of the overall system and the computational complexity of a receiver. In WCDMA interface different users can simultaneously transmit at different data rates and data rates can even vary in time. WCDMA increases data transmission rates in GSM systems by using the CDMA air interface instead of TDMA. WCDMA is based on CDMA and is the technology used in UMTS. WCDMA is the dominating 3G technology, providing higher capacity for voice and data and higher data rates. The gradual evolution from today's systems is driven by demand for capacity, which is required by new and faster data based mobile services. WCDMA enables better use of available spectrum and more cost-efficient network solutions. The operator can gradually evolve from GSM to WCDMA, protecting investments by re-using the GSM core network and 2G/2.5G services. Orthogonal Frequency Division Multiplexing (OFDM) - technique for increasing the amount of information that can be carried over a wireless network uses an FDM modulation technique for transmitting large amounts of digital data over a radio wave. OFDM works by splitting the radio signal into multiple smaller sub-signals that are then transmitted simultaneously at different frequencies to the receiver. OFDM reduces the amount of crosstalk in signal transmissions. 802.11a WLAN, 802.16 and WiMAX technologies use OFDM. It's also used in the ETSI's HiperLAN/2 standard. In addition, Japan's Mobile Multimedia Access Communications (MMAC) WLAN broadband mobile technology uses OFDM. In frequency-division multiplexing, multiple signals, or carriers, are sent simultaneously over different frequencies between two points. However, FDM has an inherent problem: Wireless signals can travel multiple paths from transmitter to receiver (by bouncing off buildings, mountains and even passing airplanes); receivers can have trouble sorting all the resulting data out. Orthogonal FDM deals with this multipath problem by splitting carriers into smaller subcarriers, and then broadcasting those simultaneously. This reduces multipath distortion and reduces RF interference allowing for greater throughput. In this paper we have discussed about these two methods of third generation radio transmission system which are WCDMA and OFDM with various aspects. In between these two radio transmission technique, a better choice will be investigated.

Place, publisher, year, edition, pages
2007. , 88 p.
Keyword [en]
National Category
URN: urn:nbn:se:bth-1365Local ID: diva2:828597
Available from: 2015-05-21 Created: 2007-01-30 Last updated: 2015-06-30Bibliographically approved

Open Access in DiVA

fulltext(1498 kB)72 downloads
File information
File name FULLTEXT01.pdfFile size 1498 kBChecksum SHA-512
Type fulltextMimetype application/pdf

By organisation
Department of Telecommunication Systems

Search outside of DiVA

GoogleGoogle Scholar
Total: 72 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 55 hits
ReferencesLink to record
Permanent link

Direct link