Change search
ReferencesLink to record
Permanent link

Direct link
Entrained flow gasification of torrefied wood residues
Umeå University, Faculty of Science and Technology, Department of Applied Physics and Electronics.
Umeå University, Faculty of Science and Technology, Department of Applied Physics and Electronics.
Show others and affiliations
2014 (English)In: Fuel processing technology, ISSN 0378-3820, E-ISSN 1873-7188, Vol. 125, 51-58 p.Article in journal (Refereed) Published
Abstract [en]

In this work, four different fuels were gasified in a pressurized entrained flow pilot plant gasifier at approximately 270 kW(th). The different fuels were; two torrefied wood residues, one raw wood residue and one torrefied stem wood. The system pressure and oxygen equivalence ratio (lambda) were held constant for all four gasification experiments. It was found that the torrefaction pretreatment significantly reduced the milling energy consumption for fuel size reduction, which in turn contributed to increased gasification plant efficiency. Furthermore, the results indicate that the carbon conversion efficiency may be enhanced by an intermediate torrefaction pretreatment, whereas both less severe torrefaction and more severe torrefaction resulted in reduced carbon conversions. The results also indicate that the CH4 yield was significantly reduced for the most severely torrefied fuel.

Place, publisher, year, edition, pages
2014. Vol. 125, 51-58 p.
Keyword [en]
Entrained-flow gasification, Biomass, Torrefaction, Wood, Syngas, Methane
National Category
URN: urn:nbn:se:umu:diva-91248DOI: 10.1016/j.fuproc.2014.03.026ISI: 000337876300006OAI: diva2:735782
Available from: 2014-07-31 Created: 2014-07-28 Last updated: 2016-01-21Bibliographically approved
In thesis
1. From torrefaction to gasification: Pilot scale studies for upgrading of biomass
Open this publication in new window or tab >>From torrefaction to gasification: Pilot scale studies for upgrading of biomass
2015 (English)Doctoral thesis, comprehensive summary (Other academic)
Alternative title[sv]
Från torrefiering till förgasning : Experiment i pilotskala för förädling av biomassa
Abstract [en]

Increasing the share of biomass, preferably by replacing fossil fuels, is one way to mitigate the present climate change. Fossil coal can be directly replaced by co-combustion of coal and biomass and fossil engine fuels (gasoline and diesel) could potentially partly be replaced by synthetic renewable fuels produced via entrained flow gasification of biomass. The use of biomass in these processes is so far limited, partly because of the fibrous and hygroscopic nature of biomass which leads to problem in storing, transportation, handling and feeding.

This thesis demonstrates how the challenging characteristics of raw biomass are mitigated by the pretreatment method torrefaction. Torrefaction is a process where biomass is heated in an oxygen deficient atmosphere to typically between 240 and 350°C for a time period of 2 minutes to 1 hour. Most of the torrefaction R&D in the literature have so far been performed with bench-scale batch reactors. For the purpose of carefully studying continuous torrefaction, a 20 kg/h torrefaction pilot plant was therefore designed, constructed and evaluated.

The overall conclusion from this thesis is that the many benefits of torrefied biomass are valid also when produced with a continuous pilot plant and for typically Swedish forest biomasses. Some of the documented improved biomass properties are increased heating value, increased energy density, higher friability (lower milling energy) and less hydrophilic biomass (less moisture uptake). Most of the improvements can be attributed to the decomposition of hemicellulose and cellulose during torrefaction.

The most common variables for describing the torrefaction degree are mass yield or anhydrous weight loss but both are challenging to determine for continuous processes. We therefore evaluated three different methods (one existing and two new suggestions) to determine degree of torrefaction that not require measurement of mass loss. The degree of torrefaction based on analyzed higher heating value of the raw and torrefied biomass (DTFHHV) predicted mass yield most accurate and had lowest combined uncertainty.

Pelletizing biomass enhance transportation and handling but results from pelletization of torrefied biomass is still very limited in the literature and mainly reported from single pellet presses. A pelletization study of torrefied spruce with a ring die in pilot scale was therefore performed. The bulk energy density was found to be 14.6 GJ/m3 for pelletized torrefied spruce (mass yield 75%), a 40% increase compared to regular white pellets and therefore are torrefied pellets more favorable for long distance transports. More optimization of the torrefied biomass and the pelletization process is though needed for acquiring industrial quality pellets with lower amount of fines and higher pellet durability than attained in the present study.

Powders from milled raw biomass are generally problematic for feeding and handling and torrefied biomass has been proposed to mitigate these issues. The influence of torrefaction and pelletization on powder and particle properties after milling was therefore studied. The results show that powder from torrefied biomass were enhanced with higher bulk densities, lower angle of repose as well as smaller less elongated particles with less surface roughness. Even higher powder qualities were achieved by pelletizing the torrefied biomass before milling, i.e. another reason for commercial torrefied biomass to be pelletized.

Entrained flow gasification (EFG) is a promising option for conversion of biomass to other more convenient renewable energy carriers such as electricity, liquid biofuels and green petrochemicals. Also for EFGs are torrefied fuels very limited studied. Raw and torrefied logging residues were successfully gasified in a pilot scale pressurized entrained flow biomass gasifier at 2 bar(a) with a fuel feed corresponding to 270 kWth. Significantly lower methane content (50% decrease) in the syngas was also demonstrated for the torrefied fuel with mass yield 49%. The low milling energy consumption for the torrefied fuels compared to the raw fuel was beneficial for the gasification plant efficiency.

Place, publisher, year, edition, pages
Umeå: Umeå universitet, 2015. 58 p.
Torrefaction, biomass, pilot scale, continuous reactor, grindability, entrained flow gasification, degree of torrefaction, biomass powder
National Category
Chemical Process Engineering
urn:nbn:se:umu:diva-103046 (URN)978-91-7601-287-1 (ISBN)
Public defence
2015-06-10, N450, Naturvetarhuset, Umeå universitet, Umeå, 13:00 (English)
Available from: 2015-05-20 Created: 2015-05-18 Last updated: 2015-05-20Bibliographically approved

Open Access in DiVA

pdf(2580 kB)89 downloads
File information
File name FULLTEXT01.pdfFile size 2580 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Other links

Publisher's full text

Search in DiVA

By author/editor
Nordwaeger, MartinOlofsson, IngemarNordin, Anders
By organisation
Department of Applied Physics and Electronics
In the same journal
Fuel processing technology

Search outside of DiVA

GoogleGoogle Scholar
Total: 89 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Altmetric score

Total: 155 hits
ReferencesLink to record
Permanent link

Direct link