Change search
ReferencesLink to record
Permanent link

Direct link
Design of an Ultra Wideband Radio Front-End for Multi-band Communications
Linköping University, Department of Science and Technology. Linköping University, The Institute of Technology.
2007 (English)Independent thesis Advanced level (degree of Master (Two Years)), 20 credits / 30 HE creditsStudent thesis
Abstract [en]

Application of multiband systems with a variety of frequency band combinations is accelerating since the communication capacity is increasing and new functions like GPS or Bluetooth are being added. It is expected, therefore, that all the handsets will probably become compatible with multibands in the near future. In such multiband systems, a multiband antenna is definitely one of the key devices since it is compatible with all the frequency bands without resort to multiple antennas as is usual in today´s practices. This project deals with design of a single antenna module for different standards, i.e., to design an ultra-wideband antenna together with frequency multiplexer. The thesis focuses on the wideband antenna design. In principle, the module must be able to work with GPS, GSM, UMTS, ZigBee, Bluetooth and Wi-Fi in the 1.5-2.5 GHz band. The antenna type chosen was the dipole antenna and it was implemented using a four metal layer PCB structure wich includes a flexible material. Two different shapes were used for the dipole, square and circular. The design process is mainly carried out in two steps. In the first step dimensions of the antennas were calculated and some results were verified in Linecalc. Then, in the second step, dimensions were experimentally tuned until simulation results fulfilled the demands of the design specifications. Evaluation was done by looking at impedance bandwidth and radiation characteristics. Simulation results showed that with perfect circular discs a correct adaptation could not be obtained in the specificated frequency band and because of this an improved circular discs antenna was designed. With this new design a good result was obtained, the voltage standing wave ratio was under 3 in the whole band. With the rectangular antenna a good result was also obtained, too. In both cases, the worst behaviour was in the middle of the bandwidth. The multiplexer structure came from a theorical design. Initial transmission line parameters were calculated in Linecalc and filters are implemented with the ADS tool. Finally, the design is experimentally tuned until good simulations results were obtained. The network insertion loss is under 2.3 dB between input port and all output ports and isolation behavior between all the different ports is satisfactory. In the end, the complete Multi-band Front-end was simulated using both antennas obtaining good behaviour for isolation and return loss parameters. In conclusion, a planar ultra wide-band front-end for GPS, GSM, UMTS, Bluetooth, WiFi, and ZigBee standards in the 1.5-2.5 GHz band using planar dipole antenna and microstrips has been designed with good simulation results.

Place, publisher, year, edition, pages
2007. , 65 p.
National Category
Engineering and Technology
URN: urn:nbn:se:liu:diva-96288ISRN: LITH-ITN-PR-07/001--SEOAI: diva2:645524
Subject / course
Electrical Engineering
Available from: 2013-09-04 Created: 2013-08-14 Last updated: 2013-09-04Bibliographically approved

Open Access in DiVA

fulltext(3650 kB)120 downloads
File information
File name FULLTEXT01.pdfFile size 3650 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
González, José Luis Alcaraz
By organisation
Department of Science and TechnologyThe Institute of Technology
Engineering and Technology

Search outside of DiVA

GoogleGoogle Scholar
Total: 120 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 60 hits
ReferencesLink to record
Permanent link

Direct link