Change search
ReferencesLink to record
Permanent link

Direct link
Impacts of Using Crushed Rocks in Concrete.
KTH, School of Architecture and the Built Environment (ABE), Land and Water Resources Engineering, Engineering Geology and Geophysics.
2011 (English)Independent thesis Advanced level (degree of Master (Two Years)), 20 credits / 30 HE creditsStudent thesis
Abstract [en]

Concrete in Sweden has traditionally been manufactured with natural aggregate from glaciofluvial eskers. There is a need to preserve the remaining eskers because of their cultural value and importance for water filtration, thus natural aggregate has to be replaced. The most realistic alternative is to use crushed rocks. The major problem with crushed rocks in concrete production is the workability. This is because crushed rocks have less favorable properties. The fragments are flakier and have a rougher surface than natural aggregates that have been rounded in water. Without any amelioration of the crushed rock, to reach a certain workability and strength, the amount of cement in the mix has to be increased. Cement production requires large amounts of energy and the decarbonation of limestone releases large amounts of CO2. Combined, the release of CO2, due to burning and decarbonation of limestone, accounts for about 5% of the global CO2 emissions. An increase in cement consumptions is less desirable. Thus to replace natural aggregates, the use of crushed rocks has to be optimized as regard cement consumption.

Several crushed aggregates, most from granitic rocks, from all over Sweden were analysed in this study. These crushed rocks were characterized according to their grading, specific surface, shape and petrography and compared to natural sand.

Rheological tests that reveals the workability in detail was performed on mortars. The tests showed that as regard workability the 0-2 mm fraction is the most important factor. Further, the maximum aggregate size was gradually increased up to 16 mm, to have a more realistic approach to the concrete produced by the building industry.

The results showed that with grading optimization and superplasticizer, some crushed rocks can be used for concrete production without increasing, and even decreasing, the cement consumption. This research also contemplated the use of filler. As a mineral admixture it can improve the compressive strength. It can also be used to replace cement; a replacement up to 20 kg/m3 of cement by filler can be done without significant effect on compressive strength.

Place, publisher, year, edition, pages
2011. , 37 p.
, TRITA-LWR Degree Project, ISSN 1651-064X ; LWR-EX-11-14
Keyword [en]
Crushed rocks, Mortar rheology, Fresh concrete workability, Cement content, Superplasticizer, Filler
National Category
Civil Engineering
URN: urn:nbn:se:kth:diva-96093OAI: diva2:529528
Educational program
Degree of Master - Environmental Engineering and Sustainable Infrastructure
Available from: 2012-05-30 Created: 2012-05-30 Last updated: 2012-05-30Bibliographically approved

Open Access in DiVA

fulltext(2631 kB)6214 downloads
File information
File name FULLTEXT01.pdfFile size 2631 kBChecksum SHA-512
Type fulltextMimetype application/pdf

By organisation
Engineering Geology and Geophysics
Civil Engineering

Search outside of DiVA

GoogleGoogle Scholar
Total: 6214 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 250 hits
ReferencesLink to record
Permanent link

Direct link