With dc magnetization and polarized neutron reflectometry we studied the ferromagnetic response of YBa₂Cu₃O₇/La_2/3Ca_1/3MnO₃ (YBCO/LCMO) multilayers that are grown with pulsed laser deposition. We found that whereas for certain growth conditions (denoted as A type) the ferromagnetic moment of the LCMO layer is strongly dependent on the structural details of the YBCO layer on which it is deposited, for others (B type) the ferromagnetism of LCMO is much more robust. Both kinds of multilayers are of similar structural quality, but electron energy-loss spectroscopy studies with a scanning transmission electron microscope reveal an enhanced average Mn oxidation state of +3.5 for the A-type as opposed to the B-type samples, for which it is close to the nominal value of +3.33. The related, additional hole doping of the A-type LCMO layers, which likely originates from La and/or Mn vacancies, can explain their fragile ferromagnetic order, since it places them close to the boundary of the ferromagnetic order at which even weak perturbations can induce an antiferromagnetic or glassy state. On the other hand, we show that the B-type samples allow one to obtain YBCO/LCMO heterostructures with very thick YBCO layers and, yet, strongly ferromagnetic LCMO layers.

Complex oxides exhibit a variety of unusual physical properties, which can be used for designing novel electronic devices. Here we fabricate and study experimentally nanoscale superconductor/ferromagnet/ superconductor junctions with the high-T_c cuprate superconductors YBa₂Cu₃O_7−x and the colossal magnetoresistive (CMR) manganite ferromagnets La_2/3X_1/3MnO_3+δ(X=CaorSr). We demonstrate that in a broad temperature range the magnetization of a manganite nanoparticle, forming the junction interface, switches abruptly in a monodomain manner. The CMR phenomenon translates the magnetization loop into a hysteretic magnetoresistance loop. The latter facilitates a memory functionality of such a junction with just a single CMR ferromagnetic layer. The orientation of the magnetization (stored information) can be read out by simply measuring the junction resistance in a finite magnetic field. The CMR facilitates a large readout signal in a small applied field. We argue that such a simple single-layer CMR junction can operate as a memory cell both in the superconducting state at cryogenic temperatures and in the normal state up to room temperature.

We fabricate and study experimentally all-perovskite-oxide superconductor/ferromagnetic insulator/superconductor (S/FI/S) tunnel junctions made out of the high-temperature cuprate superconductor YBa₂Cu₃O_7−y (YBCO) and the colossal magnetoresistive manganite LaMnO₃ (LMO) in the ferromagnetic insulator state. YBCO/LMO/YBCO heterostructures with different LMO thicknesses (5, 10, and 20 nm) are grown epitaxially via pulsed laser deposition. Nanoscale S/FI/S junctions with sizes down to 300 nm are made by three-dimensional nano-sculpturing with focused ion beam. Junctions with a thick (20 nm) LMO barrier exhibit a large negative magnetoresistance below T_Curie∼160 K, typical for colossal magnetoresistive manganites, as well as a kink in the current-voltage characteristics at large bias (V∼1–2 Volts), attributed to Zener-type tunneling. However, they do not show a measurable Josephson current. On the contrary, junctions with the thinnest 5-nm LMO barrier exhibit a large supercurrent and no signs of magnetism. The latter may indicate the presence of pinholes due to thickness inhomogeneity and/or a ∼ 2 nm dead magnetic layer at the YBCO / LMO interface caused, e.g., by interdiffusion or strain. The junction with an intermediate 10-nm LMO barrier exhibited a desired S/FI/S junction behavior with significant negative magnetoresistance and signatures of a small Josephson current.

La1.85Sr0.15CuO4/La2CuO4 (LSCO15/LCO) bilayers with a precisely controlled thickness of N unit cells (UCs) of the former and M UCs of the latter ([LSCO15_N/LCO_M]) were grown on (001)-oriented SrLaAlO4 (SLAO) substrates with pulsed laser deposition (PLD). X-ray diffraction and reciprocal space map (RSM) studies confirmed the epitaxial growth of the bilayers and showed that a [LSCO15_2/LCO_2] bilayer is fully strained, whereas a [LSCO15_2/LCO_7] bilayer is already partially relaxed. The in situ monitoring of the growth with reflection high energy electron diffraction (RHEED) revealed that the gas environment during deposition has a surprisingly strong effect on the growth mode and thus on the amount of disorder in the first UC of LSCO15 (or the first two monolayers of LSCO15 containing one CuO2 plane each). For samples grown in pure N2O gas (growth type B), the first LSCO15 UC next to the SLAO substrate is strongly disordered. This disorder is strongly reduced if the growth is performed in a mixture of N2O and O2 gas (growth type A). Electric transport measurements confirmed that the first UC of LSCO15 next to the SLAO substrate is highly resistive and shows no sign of superconductivity for growth type B, whereas it is superconducting for growth type A. Furthermore, we found, rather surprisingly, that the conductivity of the LSCO15 UC next to the LCO capping layer strongly depends on the thickness of the latter. A LCO capping layer with 7 UCs leads to a strong localization of the charge carriers in the adjacent LSCO15 UC and suppresses superconductivity. The magnetotransport data suggest a similarity with the case of weakly hole doped LSCO single crystals that are in a so-called ‘cluster-spin-glass state.’ We discussed several mechanisms that could lead to such a localization of holes that are embedded in a short-range ordered antiferromagnetic background for the case of a thick LCO capping layer with M=7 but not for a thin one with M=2.