Change search
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf
Effect of additive Cu-10Sn alloy on sintering Behavior of elemental powders in composition of 465 stainless steel
Department of Metallurgical and Materials Engineering, University of Engineering and Technology, Lahore.ORCID iD: 0000-0003-4888-6237
2007 (English)In: Journal of Iron and Steel Research International, ISSN 1006-706X, E-ISSN 2210-3988, Vol. 14, no 4, p. 61-74Article in journal (Refereed) Published
Abstract [en]

The addition of Cu-10Sn alloy for developing the high strength 465 maraging stainless steel from elemental powders was studied. The sintering parameters investigated include the sintering temperature, the sintering time, and the mass percent of Cu-10Sn. For vacuum sintering, effective sintering occurs at temperature between 1250°C and 1300°C. The maximum sintered density was achieved at 1300°C for 60 min with 3% (in mass percent) Cu-10Sn alloy. More than 3% (in mass percent) Cu-10Sn content and temperature above 1300°C caused slumping of the samples. A maximum density of 7.4 g/cm3 was achieved with 3% (in mass percent) Cu-10Sn content at a sintering temperature of 1300°C for 60 min. A maximum ultimate tensile strength (UTS) of 517 MPa was achieved with 3% (in mass percent) Cu-10Sn content. With content higher than 2% (in mass percent) Cu-10Sn, a maximum increase in the density was observed. The fracture morphologies of the sintered samples are also reported.

Place, publisher, year, edition, pages
2007. Vol. 14, no 4, p. 61-74
National Category
Other Materials Engineering
Research subject
Engineering Materials
Identifiers
URN: urn:nbn:se:ltu:diva-12935DOI: 10.1016/S1006-706X(07)60059-4Local ID: c14fefcc-3d25-43c4-93fe-1fc1284ccf5eOAI: oai:DiVA.org:ltu-12935DiVA, id: diva2:985886
Note
Upprättat; 2007; 20150416 (farakh)Available from: 2016-09-29 Created: 2016-09-29 Last updated: 2017-11-24Bibliographically approved

Open Access in DiVA

No full text in DiVA

Other links

Publisher's full text

Search in DiVA

By author/editor
Akhtar, Farid
In the same journal
Journal of Iron and Steel Research International
Other Materials Engineering

Search outside of DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric score

doi
urn-nbn
Total: 354 hits
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf