The main focus of this thesis is on the power electronic converter system challenges associated with the grid integration of variable-renewable-energy (VRE) sources like wave, marine current, tidal, wind, solar etc. Wave energy conversion with grid integration is used as the key reference, considering its high energy potential to support the future clean energy requirements and due the availability of a test facility at Uppsala University. The emphasis is on the DC-link power conditioning and grid coupling of direct driven wave energy converters (DDWECs). The DDWEC reflects the random nature of its input energy to its output voltage wave shape. Thereby, it demands for intelligent power conversion techniques to facilitate the grid connection.

One option is to improve and adapt an already existing, simple and reliable multilevel power converter technology, using smart control strategies. The proposed WECs to grid interconnection system consists of uncontrolled three-phase rectifiers, three-level boost converter(TLBC) or three-level buck-boost converter (TLBBC) and a three-level neutral point clamped (TLNPC) inverter. A new method for pulse delay control for the active balancing of DC-link capacitor voltages by using TLBC/TLBBC is presented. Duty-ratio and pulse delay control methods are combined for obtaining better voltage regulation at the DC-link and for achieving higher controllability range. The classic voltage balancing problem of the NPC inverter input, is solved efficiently using the above technique. A synchronous current compensator is used for the NPC inverter based grid coupling. Various results from both simulation and hardware testing show that the required power conditioning and power flow control can be obtained from the proposed multilevel multistage converter system.

The entire control strategies are implemented in Xilinx Virtex 5 FPGA, inside National Instruments’ CompactRIO system using LabVIEW. A contour based dead-time harmonic analysis method for TLNPC and the possibilities of having various interconnection strategies of WEC-rectifier units to complement the power converter efforts for stabilizing the DC-link, are also presented. An advanced future AC2AC direct power converter system based on Modular multilevel converter (MMC) structure developed at Siemens AG is presented briefly to demonstrate the future trends in this area.

Low speed permanent magnet (PM) synchronous generators (SGs) are commonly used in renewable energy. Rare earth (RE) PMs such as neodymium-iron-boron are a popular choice due to their high performance. In 2011 supply and cost issues were added to the previously existing environmental concerns regarding REPM raw materials as the world's major producer China imposed export restrictions. This thesis aims to investigate and propose design solutions for PMSGs that do not use REPMs. Two approaches are used: to design generators using the cheaper and more abundant ferrite PM materials, and to investigate how properties of new PM materials influence SG design.

A ferrite PM rotor is designed to replace a REPM rotor in an experimental 12 kW wind power generator. The new design employs a flux concentrating spoke type rotor to achieve performance similar to the old REPM rotor while using ferrite PMs. The ferrite PM rotor design is built. The air gap length, magnetic flux density in the air gap, PM remanence, and voltage at both load and no load are measured. The generator has lower no load voltage than expected, which is mainly explained by lower than specified remanence of the ferrite PMs in the prototype. With the measured remanence inserted into the calculations some discrepancy remains. It is found that the discrepancy can be explained by the magnetic leakage flux in the end regions of the spoke type rotor, which is not modeled in the two dimensional simulations used for the design calculations.

To investigate the influence of PM material properties three different PM rotor topologies are optimized for torque production using PM materials described by their remanence, recoil permeability, and demagnetization resistance. Demagnetization is considered using currents determined by a novel, winding design independent short circuit model. It is found that the spoke type rotor gives the highest torque of the three rotor topologies for low remanence materials as long as the PMs have sufficient demagnetization resistance. For high remanence materials the surface mounted PM rotor can give higher torque if the demagnetization resistance is high, but otherwise a capped PM rotor gives higher torque.