Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Modeling of peak-to-peak switching noise along a vertical chain of power distribution TSV pairs in a 3D stack of ICs interconnected through TSVs
KTH, Skolan för informations- och kommunikationsteknik (ICT), Elektroniksystem.
KTH, Skolan för informations- och kommunikationsteknik (ICT), Elektroniksystem.
KTH, Skolan för informations- och kommunikationsteknik (ICT), Elektroniksystem.
KTH, Skolan för informations- och kommunikationsteknik (ICT), Elektroniksystem.
2010 (Engelska)Ingår i: 28th Norchip Conference, NORCHIP 2010, 2010, artikel-id 5669473Konferensbidrag, Publicerat paper (Refereegranskat)
Abstract [en]

On-chip power supply noise has become a bottleneck in 3D ICs as scaling of the supply network impedance has not been kept up with increasing device densities and operating currents with each technology node due to limited wire resources. In this paper we proposed an efficient and accurate model to estimate peak-to-peak switching noise, caused by simultaneous switching of logic loads along a vertical chain of power distribution TSV pairs in a 3D stack of ICs. The proposed model is quite accurate with only 2-3% difference from Ansoft Nexxim4.1 equivalent model. The proposed model is 3-4 times faster than Nexxim4.1 as well as consumes two times less memory as compared to Nexxim4.1equivalent model. We analyzed peak-to-peak switching noise along a vertical chain of power distribution TSV pairs by varying physical dimensions of TSVs and value of decoupling capacitance. We also thoroughly investigated the peak-to-peak noise sensitivity to TSV effective inductance and decoupling capacitance.

Ort, förlag, år, upplaga, sidor
2010. artikel-id 5669473
Nyckelord [en]
3D stack of ICs, Power supply noise, Vertical chain
Nationell ämneskategori
Elektroteknik och elektronik
Identifikatorer
URN: urn:nbn:se:kth:diva-103505DOI: 10.1109/NORCHIP.2010.5669473Scopus ID: 2-s2.0-78751554093OAI: oai:DiVA.org:kth-103505DiVA, id: diva2:560452
Konferens
28th Norchip Conference, Tampere;15 November 2010 through16 November 2010, Finland
Anmärkning

QC 20121015

Tillgänglig från: 2012-10-15 Skapad: 2012-10-15 Senast uppdaterad: 2017-01-10Bibliografiskt granskad
Ingår i avhandling
1. Core Switching Noise for On-Chip 3D Power Distribution Networks
Öppna denna publikation i ny flik eller fönster >>Core Switching Noise for On-Chip 3D Power Distribution Networks
2012 (Engelska)Doktorsavhandling, sammanläggning (Övrigt vetenskapligt)
Abstract [en]

Reducing the interconnect size with each technology node and increasing speed with each generation increases IR-drop and Ldi/dt noise. In addition to this, the drive for more integration increases the average current requirement for modern ULSI design. Simultaneous switching of core logic blocks and I/O drivers produces large current transients due to power distribution network parasitics at high clock frequency. The current transients are injected into the power distribution planes thereby inducing noise in the supply voltage. The part of the noise that is caused by switching of the internal logic load is core switching noise. The core logic switches at much higher speed than driver speed whereas the package inductance is less than the on-chip inductance in modern BGA packages. The core switching noise is currently gaining more attention for three-dimensional integrated circuits where on-chip inductance is much higher than the board and package inductance due to smaller board, and package. The switching noise of the driver is smaller than the core switching noise due to small driver size and reduced capacitance associated with short on-board wires for three-dimensional integrated circuits. The load increases with the addition of each die. The power distribution TSV pairs to supply each extra die also introduce additional parasitic. The core switching noise may propagate through substrate and consequently through interconnecting TSVs to different dies in heterogeneous integrated system. Core switching noise may lead to decreased device drive capability, increased gate delays, logic errors, and reduced noise margins. The actual behavior of the on-chip load is not well known in the beginning of the design cycle whereas altering the design during later stages is not cost effective. The size of a three-dimensional power distribution network may reach billions of nodes with the addition of dies in a vertical stack. The traditional tools may run out of time and memory during simulation of a three-dimensional power distribution network whereas, the CAD tools for the analysis of 3D power distribution network are in the process of evolution. Compact mathematical models for the estimation of core switching noise are necessary in order to overcome the power integrity challenges associated with the 3D power distribution network design. This thesis presents three different mathematical models to estimate core switching noise for 3D stacked power distribution networks. A time-domain-based mathematical model for the estimation of design parameters of a power distribution TSV pair is also proposed. Design guidelines for the estimation of optimum decoupling capacitance based on flat output impedance are also proposed for each stage of the vertical chain of power distribution TSV pairs. A mathematical model for tradeoff between TSV resistance and amount of decoupling capacitance on each DRAM die is proposed for a 3D-DRAM-Over-Logic system. The models are developed by following a three step approach: 1) design physical model, 2) convert it to equivalent electrical model, and 3) formulate the mathematical model based on the electrical model. The accuracy, speed and memory requirement of the proposed mathematical model is compared with equivalent Ansoft Nexxim models.

Ort, förlag, år, upplaga, sidor
Stockholm: KTH Royal Institute of Technology, 2012. s. xxviii, 108
Serie
Trita-ICT-ECS AVH, ISSN 1653-6363 ; 12:06
Nationell ämneskategori
Elektroteknik och elektronik
Identifikatorer
urn:nbn:se:kth:diva-103566 (URN)978-91-7501-519-4 (ISBN)
Disputation
2012-11-07, Sal/Hal Sal E, Forum, KTH-ICT, Isafjordsgatan 39, Kista, 09:00 (Engelska)
Opponent
Handledare
Anmärkning

QC 20121015

Tillgänglig från: 2012-10-15 Skapad: 2012-10-15 Senast uppdaterad: 2012-10-15Bibliografiskt granskad

Open Access i DiVA

Fulltext saknas i DiVA

Övriga länkar

Förlagets fulltextScopus

Sök vidare i DiVA

Av författaren/redaktören
Ahmad, WaqarChen, QiangZheng, Li-RongTenhunen, Hannu
Av organisationen
Elektroniksystem
Elektroteknik och elektronik

Sök vidare utanför DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetricpoäng

doi
urn-nbn
Totalt: 279 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf