Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Experimental investigation of post-dryout heat transfer in annuli with flow obstacles
KTH, Skolan för teknikvetenskap (SCI), Fysik, Reaktorteknologi.
KTH, Skolan för teknikvetenskap (SCI), Fysik, Reaktorteknologi.ORCID-id: 0000-0001-5595-1952
KTH, Skolan för industriell teknik och management (ITM), Energiteknik, Kraft- och värmeteknologi.
2012 (Engelska)Ingår i: Nuclear Engineering and Design, ISSN 0029-5493, E-ISSN 1872-759X, Vol. 246, s. 82-90Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

An experimental study on post-dryout heat transfer was conducted in the High-pressure WAter Test (HWAT) loop at the Royal Institute of Technology in Stockholm, Sweden. The objective of the experiments was to investigate the influence of flow obstacles on the post-dryout heat transfer. The investigated operational conditions include mass flux equal to 500 kg/m2 s, inlet sub-cooling 10 K and system pressure 5 and 7 MPa. The experiments were performed in annuli in which the central rod was supported with five pin spacers. Two additional types of flow obstacles were placed in the exit part of the test section: a cylinder supported on the central rod only and a typical BWR grid spacer cell. The measurements indicate that flow obstacles improve heat transfer in the boiling channel. It has been observed that the dryout power is higher when additional obstacles are present. In addition the wall temperature in post-dryout heat transfer regime is reduced due to increased turbulence and drop deposition. The present data can be used for validation of computational models of post-dryout heat transfer in channels with flow obstacles.

Ort, förlag, år, upplaga, sidor
Elsevier, 2012. Vol. 246, s. 82-90
Nyckelord [en]
Post-dryout, flow obstacles, high spatial resolution
Nationell ämneskategori
Strömningsmekanik och akustik
Forskningsämne
SRA - Energi
Identifikatorer
URN: urn:nbn:se:kth:diva-84231DOI: 10.1016/j.nucengdes.2011.08.026ISI: 000303223000011Scopus ID: 2-s2.0-84859218375OAI: oai:DiVA.org:kth-84231DiVA, id: diva2:499282
Projekt
Experimental Study of Post- Dryout Heat Transfer in Annulus with Flow Obstacles
Forskningsfinansiär
StandUp
Anmärkning

This is the author’s version of a work that was accepted for publication in Nuclear Engineering and Design. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published in Nuclear Engineering and Design, (30 August 2011) DOI: 10.1016/j.nucengdes.2011.08.026,” Qc 20120215

Tillgänglig från: 2012-02-15 Skapad: 2012-02-13 Senast uppdaterad: 2017-12-07Bibliografiskt granskad
Ingår i avhandling
1. Experimental and theoretical study of post-dryout heat transfer in annuli with flow obstacle
Öppna denna publikation i ny flik eller fönster >>Experimental and theoretical study of post-dryout heat transfer in annuli with flow obstacle
2013 (Engelska)Doktorsavhandling, sammanläggning (Övrigt vetenskapligt)
Abstract [en]

An experimental study on post dryout heat transfer regime in annuli with flow obstacles wasconducted in the High-pressure Water Test (HWAT) loop at the Royal Institute of Technologyin Stockholm, Sweden. An annulus with flow obstacles, consisting of two concentric heatedpipes (12.7x24.3) mm, with total heated length equal to 3650 mm was employed as a testsection. The experimental investigations were performed in a wide range of the operationalconditions: mass flux (500-1750) kg/(m2s), inlet subcooling (10-40) K and system pressure(5-7) MPa. The wall superheat was measured at 88 different axial positions. A significanteffect of the flow obstacles on the wall temperature has been observed. A new correlation toevaluate the wall superheat in the post-dryout developing region and downstream of the flowobstacles was suggested. The new approach is taking into account in a combined manner theonset of the dryout point and the flow obstacle location. The coefficients and constants of thecorrelation have been optimized based on 1211 points obtained experimentally. Thecorrelation is applicable starting with the point of the onset of the dryout towards fullydeveloped post-dryout heat transfer regime and shows a correct asymptotical trend. Toaccount for the flow obstacle effect on the critical quality, an expression similar to theLevitan-Lanstman dryout correlation is suggested. The newly developed methodology can beused to predict the wall temperature in the post-dryout heat transfer regime over a wide rangeof mass fluxes and pressures typical for boiling water reactors.

Ort, förlag, år, upplaga, sidor
Stockholm: KTH Royal Institute of Technology, 2013. s. ix, 53
Serie
TRITA-FYS, ISSN 0280-316X ; 2013:60
Nyckelord
annulus, flow obstacles, critical heat flux, post-dryout, thermal margins, boiling water reactor
Nationell ämneskategori
Fysik
Forskningsämne
Fysik
Identifikatorer
urn:nbn:se:kth:diva-143210 (URN)978-91-7501-909-3 (ISBN)
Disputation
2014-03-28, FB42, AlbaNova, Roslagstullsbacken 29, Stockholm, 10:00 (Engelska)
Opponent
Handledare
Anmärkning

QC 20140319

Tillgänglig från: 2014-03-19 Skapad: 2014-03-18 Senast uppdaterad: 2014-03-24Bibliografiskt granskad

Open Access i DiVA

Experimental investigation of post-dryout heat transfer in annuli with flow obstacles(3141 kB)718 nedladdningar
Filinformation
Filnamn FULLTEXT01.pdfFilstorlek 3141 kBChecksumma SHA-512
3feaaa57a57bb10d17eba78c3d44cf9575bd70081b80eb4aa16ceaeb137a6e3a7f000f983a25e00ffcc15e151d1d9215a530e1cfa6df2f6147088ad6275d6239
Typ fulltextMimetyp application/pdf

Övriga länkar

Förlagets fulltextScopusScience direct

Sök vidare i DiVA

Av författaren/redaktören
Anghel, IonutAnglart, HenrykHedberg, Stellan
Av organisationen
ReaktorteknologiKraft- och värmeteknologi
I samma tidskrift
Nuclear Engineering and Design
Strömningsmekanik och akustik

Sök vidare utanför DiVA

GoogleGoogle Scholar
Totalt: 718 nedladdningar
Antalet nedladdningar är summan av nedladdningar för alla fulltexter. Det kan inkludera t.ex tidigare versioner som nu inte längre är tillgängliga.

doi
urn-nbn

Altmetricpoäng

doi
urn-nbn
Totalt: 656 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf