Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Model of Thermal EHL Based on Navier-Stokes Equations: Effects of Asperities and Extreme Loads
Luleå tekniska universitet, Institutionen för teknikvetenskap och matematik.
2019 (Engelska)Självständigt arbete på avancerad nivå (masterexamen), 20 poäng / 30 hpStudentuppsats (Examensarbete)
Abstract [en]

A common approach in numerical studies of elastohydrodynamic lubrication (EHL) is based on solving the Reynolds equation that governs pressure distribution in thin lubricant films. The Reynolds equation is derived from the Navier-Stokes equations by taking assumptions that are considered valid when the thickness of the lubricant film is much smaller than its length. A massive increase in the computing power over the last decades has enabled the use of CFD (computational fluid dynamics) approach, based on the Navier-Stokes equations, in solving the EHL problem. Comparisons between the CFD and Reynolds approach have generally shown very good agreement. Differences can occur when the thin film assumptions of the Reynolds equation are not applicable. In this study, a CFD approach has been chosen with the aim of investigating effects of asperities and rheology at high loads on the behavior of the thin EHL films. A high quality mesh was generated in ANSYS ICEM CFD, while ANSYS Fluent has been employed in solving the Navier-Stokes equation by finite volume method (FVM). For EHL modeling, a set of user-defined functions (UDFs) were used for computing density, viscosity, wall temperature, heat source and elastic deformation of one of the contacting surfaces. Two lubricants were used, a commonly used oil in CFD analyses of EHL and Squalane. Non-Newtonian fluid behavior and thermal effects were considered. For Squalane, the two rheology models, Ree-Eyring and Carreau were compared. Squalane has been chosen in this study since it is one of the rare fluids with known parameters for both rheology models. Finally, the influence of surface roughness was explored for the cases of a single asperity and a completely rough wall. A surface roughness profile is generated in MATLAB by using the Pearson distribution function. In the cases where the surfaces are assumed to be completely smooth, the obtained results at the pressure of about 0.5 GPa closely correspond to literature, both in the case of Newtonian and non-Newtonian fluid behavior. At the pressure of about 1 GPa, severe shearing of the lubricant film has been noticed, characterized by a pronounced shear-band and plug flow. It was found that the choice of viscosity and rheology models has a large influence on the obtained results, especially at the high pressure levels. Finally, it was discovered that the developed CFD model of EHL has a great potential in studying the effects of surface roughness on the lubricant film behavior.

Ort, förlag, år, upplaga, sidor
2019. , s. 82
Nationell ämneskategori
Tribologi (ytteknik omfattande friktion, nötning och smörjning)
Identifikatorer
URN: urn:nbn:se:ltu:diva-75694OAI: oai:DiVA.org:ltu-75694DiVA, id: diva2:1345607
Externt samarbete
Institute of Machine Elements, Technical University Munich
Ämne / kurs
Examensarbete, minst 30 hp
Utbildningsprogram
Maskinteknik, master
Presentation
2019-05-24, E241, Luleå University of Technology, 97187, Luleå, 13:30 (Engelska)
Handledare
Examinatorer
Tillgänglig från: 2019-09-05 Skapad: 2019-08-26 Senast uppdaterad: 2019-09-09Bibliografiskt granskad

Open Access i DiVA

fulltext(11089 kB)84 nedladdningar
Filinformation
Filnamn FULLTEXT01.pdfFilstorlek 11089 kBChecksumma SHA-512
7ab2591527e3c409d5de7f4d72c64f1c5718245f5b538a25e9e3842972f036166b9ae69163a61a689edb89e85006bc78edf94d72a52ecd8c721bbc50b23547b9
Typ fulltextMimetyp application/pdf

Av organisationen
Institutionen för teknikvetenskap och matematik
Tribologi (ytteknik omfattande friktion, nötning och smörjning)

Sök vidare utanför DiVA

GoogleGoogle Scholar
Totalt: 84 nedladdningar
Antalet nedladdningar är summan av nedladdningar för alla fulltexter. Det kan inkludera t.ex tidigare versioner som nu inte längre är tillgängliga.

urn-nbn

Altmetricpoäng

urn-nbn
Totalt: 1153 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf