Digitala Vetenskapliga Arkivet

Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
The Effect of N, C, Cr, and Nb Content on Silicon Nitride Coatings for Joint Applications
Uppsala Univ, Sweden.
Ionbond AG, Switzerland.
Linköpings universitet, Institutionen för fysik, kemi och biologi, Tunnfilmsfysik. Linköpings universitet, Tekniska fakulteten.ORCID-id: 0000-0002-9464-5111
Uppsala Univ, Sweden.
Visa övriga samt affilieringar
2020 (Engelska)Ingår i: Materials, E-ISSN 1996-1944, MATERIALS, Vol. 13, nr 8, artikel-id 1896Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

Ceramic coatings deposited on orthopedic implants are an alternative to achieve and maintain high wear resistance of the metallic device, and simultaneously allow for a reduction in metal ion release. Silicon nitride based (SiNx) coatings deposited by high power impulse magnetron sputtering (HiPIMS) have shown potential for use in joint replacements, as a result of an improved chemical stability in combination with a good adhesion. This study investigated the effect of N, C, Cr, and Nb content on the tribocorrosive performance of 3.7 to 8.8 mu m thick SiNx coatings deposited by HiPIMS onto CoCrMo discs. The coating composition was assessed from X-ray photoelectron spectroscopy and the surface roughness by vertical scanning interferometry. Hardness and Youngs modulus were measured by nanoindentation and coating adhesion was investigated by scratch tests. Multidirectional wear tests against ultrahigh molecular weight polyethylene pins were performed for 2 million cycles in bovine serum solution (25%) at 37 degrees C, at an estimated contact pressure of 2.1 MPa. Coatings with a relatively low hardness tended to fail earlier in the wear test, due to chemical reactions and eventually dissolution, accelerated by the tribological contact. In fact, while no definite correlation could be observed between coating composition (N: 42.6-55.5 at %, C: 0-25.7 at %, Cr: 0 or 12.8 at %, and Nb: 0-24.5 at %) and wear performance, it was apparent that high-purity and/or -density coatings (i.e., low oxygen content and high nitrogen content) were desirable to prevent coating and/or counter surface wear or failure. Coatings deposited with a higher energy fulfilled the target profile in terms of low surface roughness (Ra < 20 nm), adequate adhesion (L-c2 > 30 N), chemical stability over time in the tribocorrosive environment, as well as low polymer wear, presenting potential for a future application in joint bearings.

Ort, förlag, år, upplaga, sidor
MDPI, 2020. Vol. 13, nr 8, artikel-id 1896
Nyckelord [en]
silicon nitride; coating; joint replacement; wear; adhesion
Nationell ämneskategori
Bearbetnings-, yt- och fogningsteknik
Identifikatorer
URN: urn:nbn:se:liu:diva-166119DOI: 10.3390/ma13081896ISI: 000531829000100PubMedID: 32316517Scopus ID: 2-s2.0-85084853403OAI: oai:DiVA.org:liu-166119DiVA, id: diva2:1437070
Anmärkning

Funding Agencies|European UnionEuropean Union (EU) [FP7-NMP-2012-310477]; EBW+ Project Erasmus Mundus Programme, Action 2-STRAND 1, Lot 9 (Latin America), Brazil [2014-0982]; Swedish Government Strategic Research Area in Materials Science on Advanced Functional Materials at Linkoping University (Faculty Grant SFO Mat LiU) [2009 00971]

Tillgänglig från: 2020-06-08 Skapad: 2020-06-08 Senast uppdaterad: 2024-07-04Bibliografiskt granskad

Open Access i DiVA

fulltext(1412 kB)225 nedladdningar
Filinformation
Filnamn FULLTEXT01.pdfFilstorlek 1412 kBChecksumma SHA-512
a713b689a48d3663f60e7e8dc4d434f73bd8fb76f845befc145b6a769b26b0d3dfcd2f7342ed8d2b2505957708640dea2e1e7921326229028bb4668dfb005e1b
Typ fulltextMimetyp application/pdf

Övriga länkar

Förlagets fulltextPubMedScopus

Sök vidare i DiVA

Av författaren/redaktören
Schmidt, SusannGoyenola, CeciliaHögberg, Hans
Av organisationen
TunnfilmsfysikTekniska fakulteten
I samma tidskrift
Materials
Bearbetnings-, yt- och fogningsteknik

Sök vidare utanför DiVA

GoogleGoogle Scholar
Totalt: 225 nedladdningar
Antalet nedladdningar är summan av nedladdningar för alla fulltexter. Det kan inkludera t.ex tidigare versioner som nu inte längre är tillgängliga.

doi
pubmed
urn-nbn

Altmetricpoäng

doi
pubmed
urn-nbn
Totalt: 198 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf