Digitala Vetenskapliga Arkivet

Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Modeling and pilot plant runs of slow biomass pyrolysis in a rotary kiln
Department Chemical Engineering and Technology, KTH Royal Institute of Technology.
Luleå tekniska universitet, Institutionen för teknikvetenskap och matematik, Energivetenskap.
Cortus Energy AB.
Cortus Energy AB.
Vise andre og tillknytning
2017 (engelsk)Inngår i: Applied Energy, ISSN 0306-2619, E-ISSN 1872-9118, Vol. 207, s. 123-133Artikkel i tidsskrift (Fagfellevurdert) Published
Abstract [en]

Pyrolysis of biomass in a rotary kiln finds application both as an intermediate step in multistage gasification as well as a process on its own for the production of biochar. In this work, a numerical model for pyrolysis of lignocellulosic biomass in a rotary kiln is developed. The model is based on a set of conservation equations for mass and energy, combined with independent submodels for the pyrolysis reaction, heat transfer, and granular flow inside the kiln. The pyrolysis reaction is described by a two-step mechanism where biomass decays into gas, char, and tar that subsequently undergo further reactions; the heat transfer model accounts for conduction, convection and radiation inside the kiln; and the granular flow model is described by the well known Saeman model. The model is compared to experimental data obtained from a pilot scale rotary kiln pyrolyzer. In total 9 pilot plant trials at different feed flow rate and different heat supply were run. For moderate heat supplies we found good agreement between the model and the experiments while deviations were seen at high heat supply. Using the model to simulate various operation conditions reveals a strong interplay between heat transfer and granular flow which both are controlled by the kiln rotation speed. Also, the model indicates the importance of heat losses and lays the foundation for scale up calculations and process optimization.

sted, utgiver, år, opplag, sider
Elsevier, 2017. Vol. 207, s. 123-133
HSV kategori
Forskningsprogram
Energiteknik
Identifikatorer
URN: urn:nbn:se:ltu:diva-64494DOI: 10.1016/j.apenergy.2017.06.034ISI: 000417229300012OAI: oai:DiVA.org:ltu-64494DiVA, id: diva2:1115037
Konferanse
8th International Conference on Applied Energy (ICAE2016), Bejing, Oct 8-11, 2016
Merknad

Konferensartikel i tidskrift

Tilgjengelig fra: 2017-06-26 Laget: 2017-06-26 Sist oppdatert: 2018-10-24bibliografisk kontrollert
Inngår i avhandling
1. Biocarbon for fossil coal replacement
Åpne denne publikasjonen i ny fane eller vindu >>Biocarbon for fossil coal replacement
2018 (engelsk)Licentiatavhandling, med artikler (Annet vitenskapelig)
Alternativ tittel[sv]
Biokol for ersättning av fossil kol
Abstract [en]

This research aims to provide a full view of knowledge in charcoal production for fossil coal replacement. Charcoal from biomass is a promising material to replace fossil coal, which is using as heating source or reactant in the industrial sector. Nowadays, charcoal with quality comparable to fossil coal is produced by high-temperature pyrolysis, but efficiency of the production is relatively low due to the trade-off between charcoal property and yield by pyrolysis temperature. Increasing charcoal yield by means of secondary char formation in pyrolysis of large wood particles is the primary method considering in this work. This research has explored increasing efficiency of charcoal production by bio-oil recycling and CO2 purging. These proposed techniques significantly increase concentration and extend residence time of volatiles inside particle of woodchip resulting extra charcoal. Characterization of charcoals implies negligible effect of these methods on charcoal properties such as elemental composition, heating value, morphological structure, and chemical structure. Besides, reactivity of charcoal slightly increased when these methods were applied. A numerical model of pyrolysis in a rotary kiln reactor has been developed to study the effect of design parameters and conditions in reactor scale. The simulation results showed fair prediction of temperature profiles and products distribution along the reactor length. Nonetheless, to deliver full knowledge in charcoal production, further works are planned to be done at the end of this doctoral research.

sted, utgiver, år, opplag, sider
Luleå: Luleå University of Technology, 2018
Serie
Licentiate thesis / Luleå University of Technology, ISSN 1402-1757
Emneord
Biomass pyrolysis, charcoal, bio-oil recycling, CO2 utilization, reactivity, rotary drum
HSV kategori
Forskningsprogram
Energiteknik
Identifikatorer
urn:nbn:se:ltu:diva-71324 (URN)978-91-7790-242-3 (ISBN)978-91-7790-243-0 (ISBN)
Presentation
2018-12-11, Lueå University of Technology, Luleå, 10:56 (engelsk)
Opponent
Veileder
Tilgjengelig fra: 2018-10-25 Laget: 2018-10-24 Sist oppdatert: 2020-02-24bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fulltekst

Søk i DiVA

Av forfatter/redaktør
Phounglamcheik, Aekjuthon
Av organisasjonen
I samme tidsskrift
Applied Energy

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 247 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf