RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Oxidation behaviour of MCrAlX coatings: effect of surface treatment and an Al-activity based life criterion
Linköpings universitet, Institutionen för ekonomisk och industriell utveckling, Konstruktionsmaterial. Linköpings universitet, Tekniska fakulteten.
2018 (engelsk)Licentiatavhandling, med artikler (Annet vitenskapelig)
Abstract [en]

MCrAlY coatings (M=Ni and/or Co) have been widely used for the protection of superalloy components against oxidation and hot corrosion in the hot sections of gas turbines. The drive to improve engine combustion efficiency while reducing emissions by increasing the operation temperature brings a big challenge for coating design. As a result, the need for improvement of MCrAlY coatings for better oxidation resistance is essential.

Formation of a stable, dense, continuous, and slow-growing α-Al2O3 layer, on the MCrAlY coating surface, is the key to oxidation protection, since the protective α-Al2O3 scale offers superior oxidation resistance due to its lower oxygen-diffusion rate as compared with other oxides. The ability of a MCrAlY coating to form and maintain such a protective scale depends on the coating composition and microstructure, and can be improved through optimization of deposition parameters, modification of coating surface conditions, and so on. Part of this thesis work focuses on studying the effect of post-deposition surface treatments on the oxidation behavior of MCrAlX coatings (X can be yttrium and/or other minor alloying elements). The aim is to gain fundamental understanding of alumina scale evolution during oxidation which is important for achieving improved oxidation resistance of MCrAlX coatings. Oxide scale formed on coatings at initial oxidation stage and the effect of surface treatment were investigated by a multi-approach study combining photo-stimulated luminescence, microstructural observation and weight gain. Results showed that both mechanically polished and shot-peened coatings exhibited superior performance due to rapid formation of α-Al2O3 fully covering the coating and suppressing growth of transient alumina, assisted by the high density of α-Al2O3 nuclei on surface treatment induced defects. The early development of a two-layer alumina scale, consisting of an inward-grown inner α-Al2O3 layer and an outer layer transformed from outward-grown transient alumina, resulted in a higher oxide growth rate of the as-sprayed coating. The positive effect of the surface treatments on retarding oxide scale growth and suppressing formation of spinel was also observed in oxidation test up to 1000 hrs.

As the oxidation proceeds to the close-to-end stage, a reliable criterion to estimate the capability of coating to form α-Al2O3 is of great importance to accurately evaluate coating lifetime, which is the aim of the other part of the thesis work. Survey of published results on a number of binary Ni-Al and ternary Ni-Cr-Al, Ni-Al-Si systems shows that the empirical Al-concentration based criterion is inadequate to properly predict the formation of a continuous α-Al2O3 scale. On the other hand, correlating the corresponding Al-activity data, calculated from measured chemical compositions using the Thermo-Calc software, to the experimental oxidation results has revealed a temperature dependent, critical Al-activity value for forming continuous α-Al2O3 scale. To validate the criterion, long-term oxidation tests were performed on five MCrAlX coatings with varying compositions and the implementation of the Al-activity based criterion on these coatings successfully predicted α-Al2O3 formation, showing a good agreement with experiment results.

sted, utgiver, år, opplag, sider
Linköping: Linköping University Electronic Press, 2018. , s. 60
Serie
Linköping Studies in Science and Technology. Licentiate Thesis, ISSN 0280-7971 ; 1799
HSV kategori
Identifikatorer
URN: urn:nbn:se:liu:diva-145095DOI: 10.3384/lic.diva-145095ISBN: 9789176853818 (tryckt)OAI: oai:DiVA.org:liu-145095DiVA, id: diva2:1181845
Presentation
2018-02-23, ACAS, A-huset, Campus Valla, Linköping, 10:15 (engelsk)
Opponent
Veileder
Tilgjengelig fra: 2018-02-09 Laget: 2018-02-09 Sist oppdatert: 2018-02-13bibliografisk kontrollert
Delarbeid
1. Long-term oxidation of MCrAlY coatings at 1000 degrees C and an Al-activity based coating life criterion
Åpne denne publikasjonen i ny fane eller vindu >>Long-term oxidation of MCrAlY coatings at 1000 degrees C and an Al-activity based coating life criterion
Vise andre…
2017 (engelsk)Inngår i: Surface & Coatings Technology, ISSN 0257-8972, E-ISSN 1879-3347, Vol. 332, s. 12-21Artikkel i tidsskrift (Fagfellevurdert) Published
Abstract [en]

MCrAlY type (M = Ni and/or Co) coatings are widely used for the protection of components in the hot sections of gas turbines at high service temperatures by forming a continuous alpha-alumina. A reliable criterion to estimate the capability of coating to form alpha-alumina is of great importance to accurately evaluate coating lifetime. However, some coatings retain the ability to form a continuous alpha-alumina scale when the concentration of Al in coatings decreases to a critical level, therefore, the empirical Al-concentration based criterion is inadequate to properly predict the formation of a continuous alpha-alumina. Thus, a new life criterion, namely the critical Al-activity criterion, is proposed. In this work, the critical Al-activity to form a continuous a-alumina was validated by Al-activity calculation using Thermo-Calc software based on survey of research results of critical Al-concentration to form alpha-alumina on binary Ni-Al and ternary Ni-Cr-Al systems. Long-term oxidation tests were performed to support the criterion: three different MCrAlY coatings coated on IN-792 superalloy substrates were oxidized at 1000 degrees C for various periods of time up to 10,000 h. The microstructural evolution of MCrAlY coatings was investigated using Scanning Electron Microscope. The near-surface Al concentration and interdiffusion behaviour between substrate and coating were measured using Energy Dispersive X-ray Spectroscopy. The new critical Al-activity criterion has been successfully adopted in alpha-alumina formation prediction, showing a good agreement with experiment results. Therefore, it can be concluded that the extrapolation of new criterion from binary and ternary systems to multi-alloyed MCrAlY system is reasonable. Furthermore, the partial pressure of oxygen (P-O2) in atmosphere has been taken into consideration by combination with Al-activity to calculate the critical chemical reaction constant (K) of formation of a-alumina. The potential applicability of the methodology to predict MCrAlY life is also discussed.

sted, utgiver, år, opplag, sider
ELSEVIER SCIENCE SA, 2017
Emneord
MCrAIY; Al-activity; alpha-Alumina; Life criterion; Long-term oxidation
HSV kategori
Identifikatorer
urn:nbn:se:liu:diva-144267 (URN)10.1016/j.surfcoat.2017.09.086 (DOI)000418968100003 ()
Konferanse
44th International Conference on Metallurgical Coatings and Thin Films (ICMCTF)
Merknad

Funding Agencies|Siemens Industrial Turbomachinery AB (Finspang, Sweden); Swedish Energy Agency through KME consortium [KME-703]; research school of Agora Materials and AFM Strategic Faculty Grant SFO-MAT-LiU in Linkoping University [2009-00971]

Tilgjengelig fra: 2018-01-12 Laget: 2018-01-12 Sist oppdatert: 2018-02-09
2. Isothermal oxidation behavior of HVAF-sprayed NiCoCrAlY coatings: Effect of surface treatment
Åpne denne publikasjonen i ny fane eller vindu >>Isothermal oxidation behavior of HVAF-sprayed NiCoCrAlY coatings: Effect of surface treatment
Vise andre…
2017 (engelsk)Inngår i: Proceedings of International Thermal Sprayed Conference (ITSC), May 7-9,Germany, 456-461 (2017), 2017, s. 456-461Konferansepaper, Oral presentation only (Annet vitenskapelig)
Abstract [en]

NiCoCrAlY coatings are widely used as bond coats for ceramic thermal barrier coatings (TBCs) andoxidation and corrosion protective overlay coatings in industrial gas turbines. High temperature oxidation behaviour of NiCoCrAlYs has a great influence on the coating performance and lifetime of TBCs. A promising route to decrease the oxidation rate of such coatings is post-coating surface modification which can facilitate formation of a uniform alumina scale with a considerably slower growth rate compared to the as-sprayed coatings. In this work, the effect of surface treatment by means of shot peening and laser surface melting (LSM) on the oxidation resistance of high velocity air-fuel (HVAF) sprayed NiCoCrAlY coatings was studied. Isothermal oxidation was carried out at 1000⁰C for 1000h. Results showed that the rough surface of as-sprayed HVAF sprayed coatings was significantly changed after shot peening and LSM treatment, with a compact and smooth appearance. After the exposure, the oxide scales formed on surface-treated NiCoCrAlY coatings showed different morphology and growth rate compared to those formed on as-sprayed coating surface. The oxidation behaviour of surface treated HVAF-sprayed NiCoCrAlY coatings were revealed and discussed.

Emneord
Surface treatment, shot peening, Laser Surface Melting (LSM), High Velocity Air-Fuel (HVAF), NiCoCrAlY coating
HSV kategori
Identifikatorer
urn:nbn:se:liu:diva-145094 (URN)
Konferanse
International Thermal Spray Conference & Exposition, ITSC 2017, Düsseldorf, Germany, June 7-9, 2017
Tilgjengelig fra: 2017-12-28 Laget: 2018-02-09 Sist oppdatert: 2018-02-09

Open Access i DiVA

Oxidation behaviour of MCrAlX coatings: effect of surface treatment and an Al-activity based life criterion(4124 kB)153 nedlastinger
Filinformasjon
Fil FULLTEXT02.pdfFilstørrelse 4124 kBChecksum SHA-512
8d348e80082edde0007f21c48e251079c4b7929c44571fb94afd4d51703b25502c9ebf18bf6f11c68b6e03b65e8d010dfd07d06cf73a0754772df96640c88ca4
Type fulltextMimetype application/pdf
omslag(444 kB)4 nedlastinger
Filinformasjon
Fil COVER01.pdfFilstørrelse 444 kBChecksum SHA-512
a0db437684a7b510425cd4cf339e9239225d1728ac171d67410942f6f3759c5ffa4a168c9dabea21b70cec135a43e94efbe47f242b81be1fcac1daba14ff703f
Type coverMimetype application/pdf

Andre lenker

Forlagets fulltekst

Søk i DiVA

Av forfatter/redaktør
Zhang, Pimin
Av organisasjonen

Søk utenfor DiVA

GoogleGoogle Scholar
Totalt: 159 nedlastinger
Antall nedlastinger er summen av alle nedlastinger av alle fulltekster. Det kan for eksempel være tidligere versjoner som er ikke lenger tilgjengelige

doi
isbn
urn-nbn

Altmetric

doi
isbn
urn-nbn
Totalt: 355 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf